PID温控系统的设计及仿真(MATLAB)的设计

PID温控系统的设计及仿真(MATLAB)的设计

PID温控系统的设计及仿真(MATLAB)的设计

  • 适用:本科,大专,自考
  • 更新时间2024年
  • 原价: ¥310
  • 活动价: ¥200 (活动截止日期:2024-04-21)
  • (到期后自动恢复原价)
PID温控系统的设计及仿真(MATLAB)的设计

PID温控系统的设计及仿真(MATLAB)的设计
摘   要


温度是工业控制的主要被控参数之一,可是由于温度自身的一些特点,如惯性大,滞后现象严重,难以建立精确的数学模型等,给控制过程带来了难题。本文研究合适的控制方案对电烤箱温度进行控制,技术要求是调节时间短,超调量为零且稳态误差在±1℃内。对电烤箱这样一个被控对象进行控制,有很多方案可选。
本文分析了PID控制和模糊控制的优缺点,考虑可以把它们相互结合,实现优势互补。文中用 simulink软件对 PID 控制、模糊控制和参数模糊自整定PID 控制的控制性能和抗干扰能力分别进行了仿真研究,仿真结果表明参数模糊自整定 PID 控制能满足调节时间短、超调量为零且稳态误差在±1℃内的控制要求,且对暂态可回复性干扰、不可回复性干扰和随机干扰都有很强的抑制能力。因此本论文最终确定采用参数模糊自整定 PID 控制方案;
设计了以 AT89C52 单片机为核心的温度控制器,选用 k 型热电偶为温度传感器结合MAX6675芯片构成前向通道,同时双向晶闸管和SSR构成后向通道,由按键、LED 数码显示器及报警单元等组成人机联系电路。在进行硬件设计的同时,也设计了相应软件程序流程图。

关键词:AT89C52; PID 控制;模糊控制;仿真

 

 

 

 

 

ABSTRACT


Temperature is one of the main parameters controlled in the industrial process. But it is very difficult to control temperature well because of some characteristics of the temperature itself. For example temperature’s inertia is great, it’s time-lag is serious and it is difficult to establish accurate mathematical model of the object. This paper is to study an adapt control method to control the temperature of the electric oven, the technology demand of control method is: the regulating time must be short, the overshoot must be zero and steady-state error must be in ±1℃.For the electric oven, there are many control methods to be selected.
This paper analyses the advantages and disadvantages of the PID control and fuzzy control and comes to the method of combining them together. In the paper stimulations of PID control、fuzzy control and fuzzy self-tuning PID control are done by simulink And then the fuzzy self-tuning PID control method is selected.. because it can meet the control demands and it’s anti-interference ability is very strong.. Moreover, simulation results show that: it’s robustness is good because very good control result that the regulating time is short, the overshoot is zero and the steady-error is very little can be obtained, for first-order inertia and time-lag model.
In the paper AT89S52 is used as controller, toward access is composed of K which is used as temperature sensor, and with MAX6675 .Backward access is composed of photoelectrical coupler and Solid State Relay SSR. Man-machine circuit is composed of buttons, LED and warning unit, etc. While the hardware circuit is designed, the corresponding procedure flow chart is also designed.

Key words: AT89C52;  PID Control;  Fuzzy Control;  Stimulation;

目   录


第1章  引言 1
1.1  课题的提出及意义 1
1.2  文献综述 1
1.2.1  工业温度控制发展简介 1
1.2.2  温度微机控制系统控制方案 1
1.2.3  目前快速发展的一些具体温控方案 2
1.3  本文所做的工作 2
第2章  硬件系统 3
2.1  单片机中央控制系统 3
2.1.1  单片机简介 3
2.1.2  时钟电路 4
2.1.3  复位电路 5
2.1.4  I\O接口扩展 6
2.2  前向通道 6
2.2.1  常用形式 7
2.2.2  集成形式 7
2.3  后向通道 9
2.3.1  双向晶闸管 9
2.3.2  固体继电器SSR 9
第3章  人机通道 10
3.1  按键电路 11
3.2  数码管显示电路 12
3.3  蜂鸣报警电路 12
第4章  PID控制 14
4.1  PID 控制理论 14
4.1.1  PID 控制概述 14
4.1.2  PID 控制的基本理论 14
4.2  模糊控制理论 16
4.2.1  模糊控制概述 16
4.2.2  模糊控制的基本原理 16
4.3  模糊 PID 控制 17
第5章  仿真研究 19
5.1  仿真工具 19
5.2  MATLAB及仿真环境 simulink 19
5.3  仿真和优选。 19
5.3.1  控制对象模型 20
5.3.2  仿真 21
5.3.3  方案选择 26
第6章  单片机软件设计 26
6.1  主程序设计 27
6.2  热电偶测温查表子程序 27
6.3  滤波子程序 27
6.4  中断子程序 31
6.5  人-机接口程序 33
结束语 35

参考文献


[1] 王春霞.模糊自整定 PID 温控系统的仿真研究及设计.东北师范大学.硕士学位论文2005.5
[2] 刘洪恩.利用热电偶转换器的单片机温度测控系统.仪表技术.2005年第2期
[3] 陈浩等.热电偶测温系统原理及应用.制造业自动化.2004
[4] 朱雪璇.电热箱单片机温控系统[J].新余高专学报.2005.10
[5] 李林静.基于单片机的炉温控制系统.应用与技术.2004.第1期
[6] 李萍.单片机温度控制系统的设计与实现[J].固原师专学报.1999.12
[7] 国强.高精度恒温连续可调型温控器.哈尔滨工业大学工学硕士学位论文.2003.2
[8] 高梅娟.基于DMC- PID的串级温控系统设计.工业仪表与自动化装置.2005年第6期
[9] 彭建英.水温智能控制系统的设计.中国仪器仪表.2005年第7期
[10] 吴为民.温度控制系统的发展概况[J].《工 业 炉 》.第24卷 第2期.2002年5月
[11] 李振胜.智能PID 调节仪在湿热箱温控系统中的应用.应用 Application 
[12] 宋洪才.浅 析PID参 数 整 定.现代计量仪器与技术.2003.11
[13]  孙亮.MATLAB语言与控制系统仿真[M].北京工业大学出版社 
[14] 胡瑞雯.智能检测与控制系统[M].西安交通大学出版社.1991.
[15] 陶永华.新型PID控制极其应[M]用.机械工业出版社
[16] 鄢景华.自动控制原理[M].哈尔滨:哈尔滨工业大学出版社,1996.
[17] 模糊比例控制器在温度控制系统中的应用[J].西安邮电学院学报,2002,7(3):46-48.
[18] 吴晓莉.MATLAB 辅助模糊系统设计[M].西安:西安电子科技大学出版社, 2002.
[19] 胡泽新.多变量非线性自整定 PID 控制器[J].控制理论与应用,1996,4:268.
[20] 郑炳坤.简单的温控箱温控电路[J]. 仪器与未来..1991(7)22.
[21] 鲍可进. PID参数自整定的温度控制[J].江苏理工大学学报,
[22]  Isidro Sanchez,Julio R Banga,Antonio A Alonso.Temperature control in microwave
combination ovens[J].Journal of Food Engineering,2000,46:21-29.
[23] Roger Jang J S,ANFIS.Adaptive Network-based Fussy Interence Systems, IEEE Tran[J].System,Man and Cybernatics,1993,23(3):665-685.
[24]Diaz,GerardoCristian;Simulationandcontrolofheatexchangersusingartificialneuralnetworks.[D]UNIVERSITYOFNOTREDAME2000

 

http://www.bysj360.com/html/6486.html
http://www.bysj360.com/html/6469.html
http://www.bysj360.com/html/6483.html

  • 关键词 PID 温控 仿真 MATLAB
  • 上一篇:Matlab仿真毕业设计怎么做?代做matlab仿真毕业设计需要多少钱?
  • 下一篇:基于MATLAB的OFDM系统的设计与仿真
  • 暂无购买记录

    暂时没有评论

    真实

    多重认证,精挑细选的优质资源 优质老师。

    安全

    诚实交易,诚信为本。

    保密

    所有交易信息,都为您保密。

    专业

    10年专业经验,10年来帮助无数学子。